  /**
  @addtogroup PORT_Joystick_LEDs PORT_Joystick_LEDs for MDR1986VE91 evaluation board
  @latexonly
  @verbatim
  ******************** (C) COPYRIGHT 2024 Milandr ******************************
  * @file    readme.txt
  * @author  Milandr Application Team
  * @version V2.0.0
  * @date    16/07/2021
  * @brief   Description of the PORT_Joystick_LEDs Example.
  ******************************************************************************
  * THE PRESENT FIRMWARE IS FOR GUIDANCE ONLY. IT AIMS AT PROVIDING CUSTOMERS
  * WITH CODING INFORMATION REGARDING MILANDR'S PRODUCTS IN ORDER TO FACILITATE
  * THE USE AND SAVE TIME. MILANDR SHALL NOT BE HELD LIABLE FOR ANY
  * DIRECT, INDIRECT OR CONSEQUENTIAL DAMAGES RESULTING
  * FROM THE CONTENT OF SUCH FIRMWARE AND/OR A USE MADE BY CUSTOMERS OF THE
  * CODING INFORMATION CONTAINED HEREIN IN THEIR PRODUCTS.
  ******************************************************************************
  @endverbatim
  @endlatexonly

@par Example Description

This example shows how to use input/output ports.
PORTC is configured for input. Its 10..14 pins are connected to the joystick buttons.
PORTD is configured for output. Its 10..14 pins control LED indicators.


@par Directory contains:

    - main.c   Main program


@par Hardware and Software environment:

    - This example is intended to run on MDR1986VE91 eval board with MDR1986VE91 microcontroller.
    - "SEL", "UP", "DOWN", "LEFT" and "RIGHT" joystick buttons are connected to
      PC.10, PC.11, PC.12, PC.13 and PC.14 pins, respectively.
    - VD7, VD8, VD9, VD10, and VD11 LEDs are connected to
      PD.10, PD.11, PD.12, PD.13 and PD.14 pins, respectively.


@par How to use.

To launch the example, you must do the following:
    - Create a project and setup all project configurations.
    - Add main.c file.
    - Add the required files from "Libraries" folder:
        MDR32F9Qx_config.h
        MDR32F9Qx_port.c
        MDR32F9Qx_rst_clk.c
    - Edit the MDR32F9Qx_config.h to set appropriate run-time parameter checking level.
    - Compile and link together all .c files and load your image into the target board.
    - Run the example.

 * <h3><center>&copy; COPYRIGHT 2024 Milandr</center></h3>
 */

