  /**
  @addtogroup SPI_FullDuplex_93 SPI_FullDuplex for MDR1986VE93 evaluation board
  @latexonly
  @verbatim
  ******************** (C) COPYRIGHT 2024 Milandr ******************************
  * @file    readme.txt
  * @author  Milandr Application Team
  * @version V2.0.1
  * @date    11/11/2024
  * @brief   Description of the SPI_FullDuplex Example.
  ******************************************************************************
  * THE PRESENT FIRMWARE IS FOR GUIDANCE ONLY. IT AIMS AT PROVIDING CUSTOMERS
  * WITH CODING INFORMATION REGARDING MILANDR'S PRODUCTS IN ORDER TO FACILITATE
  * THE USE AND SAVE TIME. MILANDR SHALL NOT BE HELD LIABLE FOR ANY
  * DIRECT, INDIRECT OR CONSEQUENTIAL DAMAGES RESULTING
  * FROM THE CONTENT OF SUCH FIRMWARE AND/OR A USE MADE BY CUSTOMERS OF THE
  * CODING INFORMATION CONTAINED HEREIN IN THEIR PRODUCTS.
  ******************************************************************************
  @endverbatim
  @endlatexonly

@par Example Description

This example shows how to use SSP.
SSP configured to transfer data to itself for testing operability of the peripheral block SSP.
Configure PORTF lines 0,1,2,3 as SSP1TXD, SSP1CLK, SSP1FSS, SSP1RXD.
Configure SSP on an exchange with 16bit data frame, SPI transfer protocol and 7Kbit/s communication speed.
SSP1 transmit word on line SSP_TX and recive on line SSP_RX.
Once the transfer is completed a comparison is done and TransferStatus gives the data transfer status where it is PASSED if transmitted and received data are the same otherwise it is FAILED.


@par Directory contains:

    - main.c     Main program


@par Hardware and Software environment:

    - This example is intended to run on MDR1986VE93 eval board with MDR1986VE93 microcontroller.
    - Connect SSP1 TXD pin (X25.1.19) to SSP1 RXD pin (X25.1.22).
    - HSE oscillator is used so it should be present.


@par How to use.

To launch the example, you must do the following:
    - Create a project and setup all project configurations.
    - Add main.c file.
    - Add the required files from "Libraries" folder:
        MDR32F9Qx_config.h
        MDR32F9Qx_port.c
        MDR32F9Qx_rst_clk.c
        MDR32F9Qx_ssp.c
    - Edit the MDR32F9Qx_config.h to set appropriate run-time parameter checking level.
    - Compile and link together all .c files and load your image into the target board.
    - Run the example.

 * <h3><center>&copy; COPYRIGHT 2024 Milandr</center></h3>
 */

